HCS08 datasheet(123/374 Pages) NXP

123 / 374 page

Analog Comparator (S08ACMPV2)

MC9S08JM60 Series Data Sheet, Rev. 5

Freescale Semiconductor

123

•

An 8-bit status and control register

Refer to the direct-page register summary in the memory section of this data sheet for the absolute address

assignments for all ACMP registers.This section refers to registers and control bits only by their names.

Some MCUs may have more than one ACMP, so register names include placeholder characters to identify

which ACMP is being referenced.

8.3.1.1

ACMP Status and Control Register (ACMPSC)

ACMPSC contains the status flag and control bits which are used to enable and configure the ACMP.

765

210

ACME

ACBGS

ACF

ACIE

ACO

ACOPE

ACMOD

Reset:

000

= Unimplemented

Figure 8-3. ACMP Status and Control Register

Table 8-2. ACMP Status and Control Register Field Descriptions

Field

Description

ACME

Analog Comparator Module Enable — ACME enables the ACMP module.

0 ACMP not enabled

1 ACMP is enabled

ACBGS

Analog Comparator Bandgap Select — ACBGS is used to select between the bandgap reference voltage or

the ACMP+ pin as the input to the non-inverting input of the analog comparatorr.

0 External pin ACMP+ selected as non-inverting input to comparator

1 Internal reference select as non-inverting input to comparator

Note: refer to this chapter introduction to verify if any other config bits are necessary to enable the bandgap

reference in the chip level.

ACF

Analog Comparator Flag — ACF is set when a compare event occurs. Compare events are defined by ACMOD.

ACF is cleared by writing a one to ACF.

0 Compare event has not occurred

1 Compare event has occurred

ACIE

Analog Comparator Interrupt Enable — ACIE enables the interrupt from the ACMP. When ACIE is set, an

interrupt will be asserted when ACF is set.

0 Interrupt disabled

1 Interrupt enabled

ACO

Analog Comparator Output — Reading ACO will return the current value of the analog comparator output. ACO

is reset to a 0 and will read as a 0 when the ACMP is disabled (ACME = 0).

HCS08 bảng dữ liệu(PDF) 123 Page - NXP Semiconductors

HCS08 bảng dữ liệu(HTML) 123 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL