HCS08 datasheet(81/374 Pages) NXP

81 / 374 page

MC9S08JM60 Series Data Sheet, Rev. 5

Freescale Semiconductor

Chapter 6

Parallel Input/Output

6.1

Introduction

This chapter explains software controls related to parallel input/output (I/O). The MC9S08JM60 has seven

I/O ports which include a total of 51 general-purpose I/O pins. See Chapter 2, “Pins and Connections,” for

more information about the logic and hardware aspects of these pins.

Not all pins are available on all devices. See Table 2-1 to determine which functions are available for a

specific device.

Many of the I/O pins are shared with on-chip peripheral functions, as shown in Table 2-1. The peripheral

modules have priority over the I/Os, so when a peripheral is enabled, the I/O functions are disabled.

After reset, the shared peripheral functions are disabled so that the pins are controlled by the parallel I/O.

All of the parallel I/O are configured as inputs (PTxDDn = 0). The pin control functions for each pin are

configured as follows: slew rate control enabled (PTxSEn = 1), low drive strength selected (PTxDSn = 0),

and internal pullups disabled (PTxPEn = 0).

NOTE

Not all general-purpose I/O pins are available on all packages. To avoid

extra current drain from floating input pins, the user’s reset initialization

routine in the application program must either enable on-chip pullup devices

or change the direction of unconnected pins to outputs so the pins do not

float.

6.2

Port Data and Data Direction

Reading and writing of parallel I/O is done through the port data registers. The direction, input or output,

is controlled through the port data direction registers. The parallel I/O port function for an individual pin

is illustrated in the block diagram below.

HCS08 bảng dữ liệu(PDF) 81 Page - NXP Semiconductors