HCS08 datasheet(105/374 Pages) NXP

105 / 374 page

Chapter 7 Central Processor Unit (S08CPUV2)

MC9S08JM60 Series Data Sheet, Rev. 5

Freescale Semiconductor

105

7.3.6.7

SP-Relative, 16-Bit Offset (SP2)

This variation of indexed addressing uses the 16-bit value in the stack pointer (SP) plus a 16-bit offset

included in the instruction as the address of the operand needed to complete the instruction.

7.4

Special Operations

The CPU performs a few special operations that are similar to instructions but do not have opcodes like

other CPU instructions. In addition, a few instructions such as STOP and WAIT directly affect other MCU

circuitry. This section provides additional information about these operations.

7.4.1

Reset Sequence

Reset can be caused by a power-on-reset (POR) event, internal conditions such as the COP (computer

operating properly) watchdog, or by assertion of an external active-low reset pin. When a reset event

occurs, the CPU immediately stops whatever it is doing (the MCU does not wait for an instruction

boundary before responding to a reset event). For a more detailed discussion about how the MCU

recognizes resets and determines the source, refer to the Resets, Interrupts, and System Configuration

chapter.

The reset event is considered concluded when the sequence to determine whether the reset came from an

internal source is done and when the reset pin is no longer asserted. At the conclusion of a reset event, the

CPU performs a 6-cycle sequence to fetch the reset vector from 0xFFFE and 0xFFFF and to fill the

instruction queue in preparation for execution of the first program instruction.

7.4.2

Interrupt Sequence

When an interrupt is requested, the CPU completes the current instruction before responding to the

interrupt. At this point, the program counter is pointing at the start of the next instruction, which is where

the CPU should return after servicing the interrupt. The CPU responds to an interrupt by performing the

same sequence of operations as for a software interrupt (SWI) instruction, except the address used for the

vector fetch is determined by the highest priority interrupt that is pending when the interrupt sequence

started.

The CPU sequence for an interrupt is:

1. Store the contents of PCL, PCH, X, A, and CCR on the stack, in that order.

2. Set the I bit in the CCR.

3. Fetch the high-order half of the interrupt vector.

4. Fetch the low-order half of the interrupt vector.

5. Delay for one free bus cycle.

6. Fetch three bytes of program information starting at the address indicated by the interrupt vector

to fill the instruction queue in preparation for execution of the first instruction in the interrupt

service routine.

After the CCR contents are pushed onto the stack, the I bit in the CCR is set to prevent other interrupts

while in the interrupt service routine. Although it is possible to clear the I bit with an instruction in the

HCS08 bảng dữ liệu(PDF) 105 Page - NXP Semiconductors

HCS08 bảng dữ liệu(HTML) 105 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL