HCS08 datasheet(71/290 Pages) MOTOROLA

71 / 290 page

Data Sheet — MC9S08GB60/D V1.5

MOTOROLA

MC9S08GB/GT

IRQPE — IRQ Pin Enable

This read/write control bit enables the IRQ pin function. When this bit is set the IRQ pin can be used

as an interrupt request. Also, when this bit is set, either an internal pull-up or an internal pull-down

resistor is enabled depending on the state of the IRQMOD bit.

1 = IRQ pin function is enabled.

0 = IRQ pin function is disabled.

IRQF — IRQ Flag

This read-only status bit indicates when an interrupt request event has occurred.

1 = IRQ event detected.

0 = No IRQ request.

IRQACK — IRQ Acknowledge

This write-only bit is used to acknowledge interrupt request events (write 1 to clear IRQF). Writing 0

has no meaning or effect. Reads always return logic 0. If edge-and-level detection is selected

(IRQMOD = 1), IRQF cannot be cleared while the IRQ pin remains at its asserted level.

IRQIE — IRQ Interrupt Enable

This read/write control bit determines whether IRQ events generate a hardware interrupt request.

1 = Hardware interrupt requested whenever IRQF = 1.

0 = Hardware interrupt requests from IRQF disabled (use polling).

IRQMOD — IRQ Detection Mode

This read/write control bit selects either edge-only detection or edge-and-level detection. The

IRQEDG control bit determines the polarity of edges and levels that are detected as interrupt request

events. See 5.5.2.2 Edge and Level Sensitivity for more details.

1 = IRQ event on falling edges and low levels or on rising edges and high levels.

0 = IRQ event on falling edges or rising edges only.

5.8.2 System Reset Status Register (SRS)

This register includes seven read-only status flags to indicate the source of the most recent reset. When a

debug host forces reset by writing 1 to BDFR in the SBDFR register, none of the status bits in SRS will

be set. Writing any value to this register address clears the COP watchdog timer without affecting the

contents of this register. The reset state of these bits depends on what caused the MCU to reset.

HCS08 bảng dữ liệu(PDF) 71 Page - Motorola, Inc