| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
TMS320VC5502 bảng dữ liệu(PDF) 40 Page - Texas Instruments |
|
|
|
|||||||||||||||||||||||||||||
TMS320VC5502 bảng dữ liệu(HTML) 40 Page - Texas Instruments |
|
40 / 189 page ![]() www.ti.com 3.3.3 Serial Port 2 Mux TMS320VC5502 Fixed-Point Digital Signal Processor SPRS166H – APRIL 2001 – REVISED NOVEMBER 2004 Table 3-5. TMS320VC5502 Routing of Host Port Mux Signals PARALLEL/HOST PORT MUX MODE = 0 PARALLEL/HOST PORT MUX MODE = 1 PIN (PGPIO) (8-BIT HPI MULTIPLEXED) Data Bus HD[7:0] PGPIO[43:36] HPI.HD[7:0] Control Bus HC0 PGPIO44 HPI.HAS HC1 PGPIO45 HPI.HBIL The 5502 has three serial ports: McBSP0, McBSP1, and McBSP2, each of which has six signals. The signals for McBSP0 and McBSP1 are directly routed to pins on the 5502. Four of the pins for McBSP2 are multiplexed with two pins of the on-chip UART and two pins of the GPIO, the mode of the Serial Port 2 Mux determines which signals are routed to the 5502 pins. The mode of the Serial Port 2 Mux is determined by the state of the GPIO7 pin at reset. If GPIO7 is low, the UART is enabled and its RX and TX pins are routed to the SP1 and SP3 pins, respectively. The GPIO3 and GPIO5 pins are routed to the SP0 and SP2 pins, respectively. In this mode, McBSP2 will be disabled and any writes or reads to/from its registers will result in a bus error if the PERITOEN bit of the Time-Out Control Register is set to 1. If GPIO7 is high, McBSP2 will be enabled and its CLKX2, CLKR2, FSX2, and FSR2 signals will be routed to the SP0, SP1, SP2, and SP3 pins, respectively. In this mode, the UART will be disabled and any writes or reads to/from its registers will result in a bus error if the PERITOEN bit of the Time-Out Control Register is set to 1. GPIO3 and GPIO5 will not be available during this mode of the Serial Port 2 Mux. Table 3-6 lists the individual routing of the McBSP2, UART, and GPIO signals to the Serial Port 2 Mux pins. Table 3-6. TMS320VC5502 Routing of Serial Port 2 Mux Signals PIN SERIAL PORT 2 MUX MODE = 0 SERIAL PORT 2 MUX MODE = 1 SP0 GPIO3 CLKX2 SP1 UART.TX CLKR2 SP2 GPIO5 FSX2 SP3 UART.RX FSR2 40 Functional Overview |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |