| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
SH89F52P/044PR bảng dữ liệu(PDF) 23 Page - SINOWEALTH Electronic Ltd |
|
|
|||||||||||||||||||||||||||||
SH89F52P/044PR bảng dữ liệu(HTML) 23 Page - SINOWEALTH Electronic Ltd |
|
23 / 105 page ![]() SH88F516(SH88F54/SH89F52) 23 8.3.2 Flash Operation in ICP Mode ICP mode is performed without removing the micro-controller from the system. In ICP mode, the user system must be power-off, and the programmer can refresh the program memory through ICP programming interface. The ICP programming interface consists of 6 pins (VDD, GND, TCK, TDI, TMS, TDO). At first the four JTAG pins (TDO, TDI, TCK, TMS) are used to enter the programming mode. Only after the four pins are inputted the specified waveform, the CPU will enter the programming mode. For more detail description please refers to the FLASH Programmer’s user guide. In ICP mode,all the flash operations are completed by the programmer through 6-wire interface. Since the program signal is very sensitive, 6 jumpers are needed (VDD, GND, TDO, TDI, TCK, TMS) to separate the program pins from the application circuit, as show in the following diagram. MCU TCK TDI TDO GND To Application Circuit Jumper Flash Programmer V DD TMS When using ICP mode to do operations, the recommended steps are as following: (1) The jumpers must be open to separate the programming pins from the application circuit before programming. (2) Connect the programming interface with programmer and begin programming. (3) Disconnect programmer interface and connect jumpers to recover application circuit after programming is complete. 8.3.3 Using ISP Mode to Download Programs SH88F516 has 1k BootRom Block. The program in BootRom has been cured in it before leaving factory.Users can download user program to chips by UART port with corresponding PC software. When using this function, users only need to connect TXD & RXD of UART port with the corresponding pin of the programmer. If users choose “Enter ISP mode only when P1.0 and P1.1 are connected to GND, simultaneously. (Default)”, then they must make sure P1.0 and P1.1 are both GND. After that, the program can be downloaded correctly. See upper computer software instructions. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |