AT90SCR100 datasheet(395/433 Pages) ATMEL

395 / 433 page

395

TPR0327AY–SMS–30Jan09

AT90SCR100

29.8.15

Performing Chip Erase

1. Enter JTAG instruction PROG_COMMANDS.

2. Start Chip Erase using programming instruction 1a.

3. Poll for Chip Erase complete using programming instruction 1b.

29.8.16

Programming the Flash

Before programming the Flash a Chip Erase must be performed. See “Performing Chip Erase”

on page 395.

1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Flash write using programming instruction 2a.

3. Load address Extended High byte using programming instruction 2b.

4. Load address High byte using programming instruction 2c.

5. Load address Low byte using programming instruction 2d.

6. Load data using programming instructions 2e, 2f and 2g.

7. Repeat steps 5 and 6 for all instruction words in the page.

8. Write the page using programming instruction 2h.

9. Poll for Flash write complete using programming instruction 2i.

10. Repeat steps 3 to 9 until all data have been programmed.

A more efficient data transfer can be achieved using the PROG_PAGELOAD instruction:

1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Flash write using programming instruction 2a.

3. Load the page address using programming instructions 2b, 2c and 2d. PCWORD (refer

to Table 29-7 on page 381) is used to address within one page and must be written as

4. Enter JTAG instruction PROG_PAGELOAD.

5. Load the entire page by shifting in all instruction words in the page byte-by-byte, start-

ing with the LSB of the first instruction in the page and ending with the MSB of the last

instruction in the page. Use Update-DR to copy the contents of the Flash Data Byte

before each new word.

6. Enter JTAG instruction PROG_COMMANDS.

7. Write the page using programming instruction 2h.

8. Poll for Flash write complete using programming instruction 2i.

9. Repeat steps 3 to 8 until all data have been programmed.

29.8.17

Reading the Flash

1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Flash read using programming instruction 3a.

3. Load address using programming instructions 3b, 3c and 3d.

4. Read data using programming instruction 3e.

5. Repeat steps 3 and 4 until all data have been read.

A more efficient data transfer can be achieved using the PROG_PAGEREAD instruction:

1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Flash read using programming instruction 3a.

AT90SCR100 bảng dữ liệu(PDF) 395 Page - ATMEL Corporation

AT90SCR100 bảng dữ liệu(HTML) 395 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL