AT90SCR100 datasheet(78/433 Pages) ATMEL

78 / 433 page

TPR0327AY–SMS–30Jan09

AT90SCR100

Figure 12-4.

General Digital I/O

12.4.1

Configuring the Pin

Each port pin consists of three register bits: DDxn, PORTxn, and PINxn. As shown in “Register

Description for I/O-Ports” on page 83, the DDxn bits are accessed at the DDRx I/O address, the

PORTxn bits at the PORTx I/O address, and the PINxn bits at the PINx I/O address.

The DDxn bit in the DDRx Register selects the direction of this pin. If DDxn is written logic one,

Pxn is configured as an output pin. If DDxn is written logic zero, Pxn is configured as an input

pin.

If PORTxn is written logic one when the pin is configured as an input pin, the pull-up resistor is

activated. To switch the pull-up resistor off, PORTxn has to be written logic zero or the pin has to

WRx, WPx, WDx, RRx, RPx, and RDx are common to all pins within the same

port. clkI/O, SLEEP, and PUD are common to all ports.

clk

RPx

RRx

RDx

WDx

PUD

SYNCHRONIZER

WDx:

WRITE DDRx

WRx:

WRITE PORTx

RRx:

READ PORTx REGISTER

RPx:

READ PORTx PIN

PUD:

PULLUP DISABLE

clk

I/O:

I/O CLOCK

RDx:

READ DDRx

RESET

CLR

PORTxn

CLR

DDxn

PINxn

SLEEP

SLEEP:

SLEEP CONTROL

Pxn

I/O

WPx

WRx

WPx:

WRITE PINx REGISTER

Note

AT90SCR100 bảng dữ liệu(PDF) 78 Page - ATMEL Corporation

AT90SCR100 bảng dữ liệu(HTML) 78 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL