| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
T83C5121XXX-ICSIL bảng dữ liệu(PDF) 17 Page - ATMEL Corporation |
|
|
|||||||||||||||||||||||||||||
T83C5121XXX-ICSIL bảng dữ liệu(HTML) 17 Page - ATMEL Corporation |
|
17 / 115 page ![]() 17 A/T8xC5121 4164G–SCR–07/06 The ports status under Power-down is the status which was valid before entering this mode. The INT1 interrupt is a multiplexed input (see Interrupt paragraph) with CPRES (Card detection) and Rxd (UART Rx). So these three inputs can be used to exit from Power- down mode. The configurations which must be set are detailed below: • Rxd input: – RXEN (ISEL.0) must be set – EX1 (IE0.2) must be set – A low level detected during more than 100 microseconds exit from Power- down • CPRES input: – PRSEN (ISEL.1) must be set – EX1 (IEO.2) must be set – EA (IE0.7) must be set – In the INT1 interrupt vector, the CPLEV Bit (ISEL.7) must be inverted and PRESIT Bit (ISEL.5) must be reset. Figure 10. Power-down Exit Waveform Exiting from Power-down by reset redefines all the SFRs, exiting from Power-down by external interrupt does no affect the SFRs. Exiting from Power-down by either reset or external interrupt does not affect the internal RAM content. Note: If idle mode is activated with Power-down mode (IDL and PD bits set), the exit sequence is unchanged, when execution is vectored to interrupt, PD and IDL bits are cleared and idle mode is not entered. SCI Control Prior to entering Power-down mode, a de-activation of the Smart Card system must be performed. LED Control Prior to entering Power-down mode, if the LED mode output is used, the medium pull-up must be disconnected by setting the LEDPD bit in the PCON Register (PCON 3). Low Power Mode Only in Power-down mode, in order to reduce the power consumption, the user can choose to select this low-power mode. The activation reference is the following. • First select the Low-power mode by setting the LP bit in the AUXR Register (AUXR. 6) • The activation of Power-down can then be done. INT1 INT0 XTAL1 Power-down phase Oscillator restart phase Active phase Active phase |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |