X11SSL datasheet(68/124 Pages) ETC1

68 / 124 page

X11SSM(-F)/X11SSL(-F) User Manual

6. Proper software support: Make sure that the correct drivers are used.

B. If the system becomes unstable before or during OS installation, check the following:

1. Source of installation: Make sure that the devices used for installation are working

properly, including boot devices such as CD/DVD and CD/DVD-ROM.

2. Cable connection: Check to make sure that all cables are connected and working

properly.

3. Using the minimum configuration for troubleshooting: Remove all unnecessary

components (starting with add-on cards first), and use the minimum configuration (but

with the CPU and a memory module installed) to identify the trouble areas. Refer to the

steps listed in Section A above for proper troubleshooting procedures.

4. Identifying bad components by isolating them: If necessary, remove a component in

question from the chassis, and test it in isolation to make sure that it works properly.

Replace a bad component with a good one.

5. Check and change one component at a time instead of changing several items at the

same time. This will help isolate and identify the problem.

6. To find out if a component is good, swap this component with a new one to see if the

system will work properly. If so, then the old component is bad. You can also install the

component in question in another system. If the new system works, the component is

good and the old system has problems.

X11SSL bảng dữ liệu(PDF) 68 Page - List of Unclassifed Manufacturers