X11SSL datasheet(88/124 Pages) ETC1

88 / 124 page

X11SSM(-F)/X11SSL(-F) User Manual

Port 0 ~ Port 7 Spin Up Device (Port 6 and Port 7 on X11SSM-F only)

On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The

options are Enabled and

Disabled.

Port 0 ~ Port 7 SATA Device Type (Port 6 and Port 7 on X11SSM-F only)

Use this item to specify if the SATA port specified by the user should be connected to a Solid

State drive or a Hard Disk Drive. The options are

Hard Disk Drive and Solid State Drive.



PCIe/PCI/PnP Configuration

The following information will display:

• PCI Bus Driver Version

• PCI Devices Common Settings:

PCI Latency Timer

Use this feature to set the latency Timer of each PCI device installed on a PCI bus. Select

32 to set the PCI latency to 32 PCI clock cycles. The options are

32 PCI Bus Clocks, 64

PCI Bus Clocks, 96 PCI Bus Clocks, 128 PCI Bus Clocks, 160 PCI Bus Clocks, 192 PCI Bus

Clocks, 224 PCI Bus Clocks, and 248 PCI Bus Clocks.

PCI PERR/SERR Support

Select Enabled to allow a PCI device to generate a PERR/SERR number for a PCI Bus Signal

Error Event. The options are Enabled and

Disabled.

Above 4G Decoding (Available if the system supports 64-bit PCI decoding)

Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.

The options are Enabled and

Disabled.

PCH SLOT4 PCI-E 3.0 X4 (IN X8) OPROM (X11SSM-F only)

Use this feature to select which firmware type to be loaded for the add-on card in this slot.

The options are Disabled,

Legacy, and EFI.

PCH SLOT5 PCI-E 3.0 X4 (IN X8) OPROM

Use this feature to select which firmware type to be loaded for the add-on card in this slot.

The options are Disabled,

Legacy, and EFI.

CPU SLOT6 PCI-E 3.0 X8 (IN X16) OPROM

Use this feature to select which firmware type to be loaded for the add-on card in this slot.

The options are Disabled,

Legacy, and EFI.

X11SSL bảng dữ liệu(PDF) 88 Page - List of Unclassifed Manufacturers