AM79C940KCSLASHW datasheet(70/144 Pages) AMD

70 / 144 page

Am79C940

software reset). After a hardware or software reset and

before the ENRCV bit in the MAC Configuration Con-

trol register has been set, the Logical Address can be

accessed by setting the LOG ADDR bit in the Internal

Address Configuration register (REG ADDR 18) and

then by performing 8 reads or writes to the Logical

Address Filter. Once ENRCV has been set, the ADDR

CHG bit in the Internal Address Configuration register

must be set and be polled until it is cleared by the

MACE device before setting the LOGADDR bit and

before accessing of the Logical Address Filter is

allowed.

If the least significant address bit of a received

message is set (Destination Address bit 00 = 1), then

the address is deemed logical, and passed through the

FCS generator. After processing the 48-bit destination

address, a 32-bit resultant FCS is produced and

strobed into an internal register. The high order 6-bits

of this resultant FCS are used to select one of the 64-bit

positions in the Logical Address Filter (see diagram). If

the selected filter bit is a 1, the address is accepted and

the packet will be placed in memory.

The first bit of the incoming address must be a 1 for a

logical address. If the first bit is a 0, it is a physical

address and is compared against the value stored in

the Physical Address Register at initialization.

The Logical Address Filter is used in multicast address-

ing schemes. The acceptance of the incoming frame

based on the filter value indicates that the message

may be intended for the node. It is the user’s responsi-

bility to determine if the message is actually intended

for the node by comparing the destination address of

the stored message with a list of acceptable logical

addresses.

The Broadcast address, which is all ones, does not go

through the Logical Address Filter and is always

enabled provided the Disable Receive Broadcast bit

(DRCVBC in the MAC Configuration Control register) is

cleared. If the Logical Address Filter is loaded with all

zeroes (and PROM = 0), all incoming logical addresses

except broadcast will be rejected.

Multicast addressing can only be performed when

using external loopback (LOOP [1–0] = 0) by pro-

gramming RCVFCSE = 1 in the User Test Register.

The FCS logic is internally allocated to the receiver

section, allowing the FCS to be computed on the in-

coming logical address.

Received Message

Destination Address

CRC

GEN

SEL

MUX

MATCH*

MATCH = 1:

MATCH = 0:

Packet Accepted

Packet Rejected

Logical

Address

Filter

(LADRF)

32-Bit Resultant CRC

16235D-10

Logical Address Match Logic

AM79C940KC/W bảng dữ liệu(PDF) 70 Page - Advanced Micro Devices

AM79C940KC/W bảng dữ liệu(HTML) 70 Page - Advanced Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL