VR4102 datasheet(182/701 Pages) NEC

182 / 701 page

CHAPTER 6 EXCEPTION PROCESSING

182

(2) TLB Invalid Exception

Cause

The TLB Invalid exception occurs when the TLB entry that matches with the virtual address to be referenced is

invalid (the V bit is set to 0). This exception is not maskable.

Processing

The common exception vector is used for this exception. The TLBL or TLBS code in the ExcCode field of the

Cause register is set. If this exception has been caused by an instruction reference or load operation, TLBL is

set. If it has been caused by a store operation, TLBS is set.

When this exception occurs, the BadVAddr, Context, Xcontext, and EntryHi registers contain the virtual address

that failed address translation.

The EntryHi register also contains the ASID from which the translation fault

occurred. The Random register normally stores a valid location in which to place the replacement TLB entry.

The contents of the EntryLo register are undefined.

The EPC register contains the address of the instruction that caused the exception unless this instruction is in a

branch delay slot, in which case the EPC register contains the address of the preceding branch instruction and

the BD bit of the Cause register is set to 1.

Servicing

Usually, the V bit of a TLB entry is cleared in the following cases:

When a virtual address does not exist

When the virtual address exists, but is not in main memory (a page fault)

When a trap is required on any reference to the page (for example, to maintain a reference bit)

After servicing the cause of a TLB Invalid exception, the TLB entry is located with a TLBP (TLB Probe) instruction,

and replaced by an entry with its Valid bit set to 1.

VR4102 bảng dữ liệu(PDF) 182 Page - NEC