EN25Q64-104FIP datasheet(43/60 Pages) EON

43 / 60 page

This Data Sheet may be revised by subsequent versions

www.eonssi.com

or modifications due to changes in technical specifications.

EN25Q64

Rev. J, Issue Date: 2011/07/07

Figure 25.1. Read Identification (RDID) under EQPI Mode

Enter OTP Mode (3Ah)

This Flash has an extra 512 bytes OTP sector, user must issue ENTER OTP MODE command to read,

program or erase OTP sector. After entering OTP mode, the OTP sector is mapping to sector 2047,

SRP bit becomes OTP_LOCK bit and can be read with RDSR command. Program / Erase command

will be disabled when OTP_LOCK bit is ‘1’

WRSR command will ignore the input data and program OTP_LOCK bit to 1.

User must clear the protect bits before enter OTP mode.

OTP sector can only be program and erase before OTP_LOCK bit is set to ‘1’ and BP [3:0] = ‘0000’. In

OTP mode, user can read other sectors, but program/erase other sectors only allowed when

OTP_LOCK bit equal to ‘0’.

User can use WRDI (04h) command to exit OTP mode.

While in OTP mode, user can use Sector Erase (20h) command only to erase OTP data.

The instruction sequence is shown in Figure 26.1 while using the Enable Quad Peripheral Interface mode

(EQPI) (38h) command.

Table 7. OTP Sector Address

Sector

Sector Size

Address Range

2047

512 byte

7FF000h – 7FF1FFh

Note:

The OTP sector is mapping to sector 2047

EN25Q64-104FIP bảng dữ liệu(PDF) 43 Page - Eon Silicon Solution Inc.