ST20-C1 datasheet(53/205 Pages) STMICROELECTRONICS

53 / 205 page

53/205

4 Using ST20-C1 instructions

Any bit may be read from the IO register by:

ldc 0; dup; io;

ldc bit_number; bitld;

The IO register is global and is not changed or saved by a context switch. If more than

one process accesses the IO register then it may need to be protected by a sema-

phore. On reset the IO register is set to all zeros.

4.11.2 Memory-mapped peripherals

On-chip peripherals may have memory-mapped registers in the address space

Access to these registers is performed in the same way as accessing memory. If a

peripheral has a block of word-aligned registers with base address

peripheral then a

ld peripheral;

ldnl register;

and

value may be written to the register by:

ld value;

ld peripheral;

stnl register;

4.11.3 Channel-type peripherals

Some peripherals, for example peripherals using DMA (direct memory access), may

use a channel-type control model. This section describes how to use such periph-

erals, which use a micro-interrupt to notify the CPU that an assigned job is completed.

This type of peripheral works best with a multi-tasking program, so that the CPU has

other processes to execute while the peripheral is busy. However, if multi-tasking is not

otherwise required, then an interrupt model can be used. Multi-tasking is described in

Chapter 7 and interrupts and the exception vector table are described in Chapter 6.

Multi-tasking

The principle of using the channel model with multi-tasking is that the CPU tells the

peripheral to start a job and then deschedules the current process. The job might be

peripheral input/output or DMA transfer. This allows the CPU to continue executing

other processes while the job is in progress. When the peripheral completes the job it

signals to the CPU, which reschedules the process.

To enable this to happen, the task descriptor of a user process can be entered into the

exception vector table. This entry is called the peripheral channel. The peripheral

signals a micro-interrupt, which interrupts the CPU with the exception level associated

with the user process. The CPU recognizes that the exception vector table entry is a

user process because bit zero is

UserProcessType, and either adds the process to the

end of the scheduling queue or takes a schedule exception trap if installed. The

scheduling exception trap allows a scheduling kernel to control the rescheduling of the

process.

In more detail, the steps to perform a job using this model are:

ST20-C1 bảng dữ liệu(PDF) 53 Page - STMicroelectronics

ST20-C1 bảng dữ liệu(HTML) 53 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL