TMPR4925 datasheet(79/590 Pages) TOSHIBA

79 / 590 page

Chapter 4 Address Mapping

4-1

Address Mapping

This chapter explains the physical address map of TX4925.

Please refer to “64-Bit TX System RISC TX49/H2 Core Architecture” about the details of mapping to a

physical address from the virtual address of TX49/H2 core.

4.1

TX4925 Physical Address Map

TX4925 supports up to 4G (2

32) bytes of physical address.

Following resources are to be allocated in the physical address of the TX4925.

•

TX4925 Internal registers (refer to “4.2 Register Map”)

•

SDRAM (refer to “9.3.2 Address Mapping”)

•

External Devices such as ROM, I/O Devices (refer to “7.3.3 Address Mapping”)

•

PCI Bus (refer to “10.3.4 Initiator Access”)

Each resource is to be allocated in arbitrary physical addresses by the register setup. Refer to the

explanation of each controller for the details of the mapping.

At initialization, only the internal registers and the memory space which stores the TX49/H2 core reset

vectors are allocated shown as Figure 4.1.1. Usually ROM connected to the external bus controller channel 0

is used for the memory device that stores the reset vectors. TX4925 also supports using the memories on PCI

bus as the memory device stores the reset vectors. Refer to “10.3.12 PCI Boot Configuration” for detail

about this.

Figure 4.1.1 Physical Address Map at Initializing System

It is possible to access a resource of TX4925 as a PCI target device through PCI bus. About how to

allocate resources of TX4925 to the PCI bus address space, refer to “10.3.5 Target Access”.

TX4925 Internal Register

External Bus Controller Channel 0

64 K Bytes

0xFFFF_FFFF

0xFF1F_FFFF

0xFF1F_0000

0x1FFF_FFFF

0x1FC0_0000

0x0000_0000

4 M Bytes

TMPR4925 bảng dữ liệu(PDF) 79 Page - Toshiba Semiconductor