MPC821 datasheet(158/242 Pages) NXP

158 / 242 page

Support Information

MPC8XXFADS Design Specification—Rev 0.1

PRELIMINARY—SUBJECT TO CHANGE WITHOUT NOTICE

FIGURE A-1 Physical Location of jumper JG1 and JG2

NOTE: Jumper JG2 should be left unconnected.

The following figure shows the required jumper connection for each address configuration. Address

0 hex is not recommended, and its usage might cause problems.

FIGURE A-2 JG1 Configuration Options

To properly install the ADI board, position its front bottom corner in the plastic card guide channel at

the front of the IBM-PC/XT/AT chassis. Keeping the top of the ADI board level and any ribbon cables

out of the way, lower the board until its connectors are aligned with the computer expansion slot

connectors. Using evenly distributed pressure, press the ADI board straight down until it seats in the

expansion slot.

Secure the ADI board to the computer chassis using the bracket retaining screw. Refer to the

computer Installation and Setup manual for instructions on reinstalling the computer cover.

C•3

SUN-4 to MPC8XXFADS Interface

The ADI board should be installed in one of the SBus expansion slots in the Sun-4 SPARCstation

computer. A single ADI can control up to eight MPC8XXFADS boards.

JG1

JG2

0 hex

100 hex

200 hex

300 hex

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

MPC821 bảng dữ liệu(PDF) 158 Page - NXP Semiconductors