HC05RC17GRSSLASHD datasheet(88/128 Pages) NXP

88 / 128 page

Phase-Locked Loop (PLL) Synthesizer

General Release Specification

MC68HC05RC17 — Rev. 2.0

Phase-Locked Loop (PLL) Synthesizer

Figure 10-1. PLL Circuit

To change PLL frequencies, follow this 6-step procedure:

1. Clear BCS to enable the low frequency bus rate

2. Clear PLLON to disable the PLL and select manual high

bandwidth

3. Select the speed using PS1 and PS0

4. Set PLLON to enable the PLL

5. Wait a time of 90% tPLLS for the PLL frequency to stabilize and

select manual low bandwidth, wait another 10% tPLLS

NOTE:

Typically, tPLLS equals 10 ms.

6. Set BCS to switch to the high-frequency bus rate

The user cannot switch among the high speeds with the BCS bit set.

Following the procedure above will prevent possible bursts of high

frequency operation during the re-configuration of the PLL.

Whenever the PLL is first enabled, the wide bandwidth mode is used.

This enables the PLL frequency to ramp up quickly. When the output

frequency is near the desired frequency, the filter is switched to the

narrow bandwidth mode to make the final frequency more stable.

LOOP FILTER

VCO

PHASE

PCOMP

PLLOUT

FREQUENCY

DIVIDER

OSC1

XFC

CRYSTAL

OSCILLATOR

PS1

PS0

TO CLOCK

DDSYN

DETECT

GENERATION

CIRCUITRY

CLOCK

SELECT

BCS

REF

0.1

µF

0.1

µF

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC05RC17GRS/D bảng dữ liệu(PDF) 88 Page - NXP Semiconductors

HC05RC17GRS/D bảng dữ liệu(HTML) 88 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL