26HS01GTAM03 datasheet(100/166 Pages) INFINEON

100 / 166 page

Datasheet

100 of 166

002-12337 Rev. *Y

2022-01-18

256Mb/512Mb/1Gb SEMPER™ Flash

HYPERBUS™ interface, 1.8V/3.0V

Registers

5.2.12

AutoBoot register (ATBN) (x8)

The AutoBoot Register (ATBN) provides a means to automatically read boot code as part of the power-on reset,

or hardware reset process.

5.2.13

POR time register (PORT) (x8)

The POR Time register contain the count by which the RSTO# period is extended beyond POR period.

5.2.14

Sector erase count register (SECV) (x8)

The Sector Erase Count Register (SECV) contains the number of times the addressed sector has been erased.

Table 79

AutoBoot register (x8)

Bit number

Name

Function

Read/write

N = Nonvolatile

V = Volatile

Factory

default

(binary)

Description

ATBN[31:9]

STADR[22:0]

Starting Address Selection

where AutoBoot will start

reading data from

N => R/W

0000000000

000

Description: The STADR[22:0] bits set the starting

address from which the device will output the read data.

Selection Options: Address Bits

Dependency: N/A

ATBN[8:1]

STDLY[7:0]

AutoBoot Read Starting

Delay Selection

N => R/W

00000000

The STDLY[7:0] bits specify the initial delay (clock cycles)

needed by the host before it can accept data.

Note STDLY[7:0]=0x00 is valid for SPI up to 50MHz.

STDLY[8:1]=0x01 or higher is valid for SPI/DPI/QPI up to

166MHz. STDLY[7:0] = 0x05 or higher is valid for

OPI/HYPERFLASH™ up to 200MHz.

Selection Options: Address Bits

Dependency: N/A

ATBN[0]

ATBTEN

AutoBoot Feature

Selection

N => R/W

Description: The ATBTEN bit enables or disables the

AutoBoot feature.

Selection Options:

0 = AutoBoot feature disabled

1 = AutoBoot feature enabled

Dependency: N/A

Table 80

POR time register (x8)

Non-Volatile-Memory Core Bits

Description

Bits

Name

Function

Read/write

Default

state

15:0

PORT_NV

Power-On-Reset Time

R/W

FFFFh

To extend the RSTO# period beyond the POR period, the

non-volatile POR Time Register must be programmed.

0000000000000000b

...............................

1111111111111111b

Table 81

Sector erase count register (x8)

Bit number

Name

Function

Read/write

N = Nonvolatile

V = Volatile

Factory

default

(binary)

Description

SECV[31:24]

RESVRD

Reserved for Future Use

V => R

11111111

This bit is Reserved for future use. This bit must always

be written/loaded to its default state.

26HS01GTAM03 bảng dữ liệu(PDF) 100 Page - Infineon Technologies AG

26HS01GTAM03 bảng dữ liệu(HTML) 100 Page - Infineon Technologies AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL