Z8F082ASH020SC datasheet(79/244 Pages) ZILOG

79 / 244 page

PS024705-0405

P R E L I M I N A R Y

Timers

Z8 Encore! XP® F08xA Series

Product Specification

–

If using the Timer Output alternate function, set the initial output level (High or

Low).

2. Write to the Timer High and Low Byte registers to set the starting count value (usually

0001H

). This action only affects the first pass in CONTINUOUS mode. After the first

timer Reload in CONTINUOUS mode, counting always begins at the reset value of

0001H

3. Write to the Timer Reload High and Low Byte registers to set the Reload value.

4. Enable the timer interrupt (if appropriate) and set the timer interrupt priority by

writing to the relevant interrupt registers.

5. Configure the associated GPIO port pin (if using the Timer Output function) for the

Timer Output alternate function.

6. Write to the Timer Control register to enable the timer and initiate counting.

In CONTINUOUS mode, the system clock always provides the timer input. The timer

period is given by the following equation:

If an initial starting value other than 0001H is loaded into the Timer High and Low Byte

registers, use the ONE-SHOT mode equation to determine the first time-out period.

COUNTER Mode

In COUNTER mode, the timer counts input transitions from a GPIO port pin. The timer

input is taken from the GPIO Port pin Timer Input alternate function. The TPOL bit in the

Timer Control Register selects whether the count occurs on the rising edge or the falling

edge of the Timer Input signal. In COUNTER mode, the prescaler is disabled.

The input frequency of the Timer Input signal must not exceed one-fourth the system

clock frequency.

Upon reaching the Reload value stored in the Timer Reload High and Low Byte registers,

the timer generates an interrupt, the count value in the Timer High and Low Byte registers

is reset to 0001H and counting resumes. Also, if the Timer Output alternate function is

enabled, the Timer Output pin changes state (from Low to High or from High to Low) at

timer Reload.

The steps for configuring a timer for COUNTER mode and initiating the count are as fol-

lows:

1. Write to the Timer Control register to:

–

Disable the timer

–

Configure the timer for COUNTER mode

Continuous Mode Time-Out Period (s)

Reload Value

Prescale

System Clock Frequency (Hz)

----------------------------------------------------------------------------

Caution:

Z8F082ASH020SC bảng dữ liệu(PDF) 79 Page - Zilog, Inc.

Z8F082ASH020SC bảng dữ liệu(HTML) 79 Page - Zilog, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL