DP83848JSQSLASHNOPB datasheet(71/84 Pages) TI1

71 / 84 page

Avoid

Stubs

Does Not Maintain Parallelism

Ground or Power Plane

DP83848H, DP83848J, DP83848K, DP83848M, DP83848T

www.ti.com

SNLS250E – MAY 2008 – REVISED APRIL 2015

7.3

Layout

7.3.1

Layout Guidelines

Place the 49.9-

Ω,1% resistors, and 0.1-μF decoupling capacitor near the PHYTER TD+/- and RD+/- pins

and via directly to the VDD plane.

Stubs should be avoided on all signal traces, especially the differential signal pairs. See Figure 7-11.

Within the pairs (for example, TD+ and TD-) the trace lengths should be run parallel to each other and

matched in length. Matched lengths minimize delay differences, avoiding an increase in common mode

noise and increased EMI. See Figure 7-11.

Figure 7-11. Differential Signal Pair - Stubs

Ideally, there should be no crossover or via on the signal paths. Vias present impedance discontinuities

and should be minimized. Route an entire trace pair on a single layer if possible. PCB trace lengths

should be kept as short as possible.

Signal traces should not be run such that they cross a plane split. See Figure 7-12. A signal crossing a

plane split may cause unpredictable return path currents and would likely impact signal quality as well,

potentially creating EMI problems.

Application, Implementation, and Layout

Submit Documentation Feedback

Product Folder Links: DP83848H DP83848J DP83848K DP83848M DP83848T

DP83848JSQ/NOPB bảng dữ liệu(PDF) 71 Page - Texas Instruments