DS72011RB120FPV datasheet(161/1196 Pages) RENESAS

161 / 1196 page

Section 6 Interrupt Controller (INTC)

Rev. 2.00 Sep. 07, 2007 Page 133 of 1164

REJ09B0321-0200

6.4

Interrupt Sources

There are six types of interrupt sources: NMI, user break, H-UDI, IRQ, PINT, and on-chip

peripheral modules. Each interrupt has a priority level (0 to 16), with 0 the lowest and 16 the

highest. When set to level 0, that interrupt is masked at all times.

6.4.1

NMI Interrupt

The NMI interrupt has a priority level of 16 and is accepted at all times. NMI interrupt requests

are edge-detected, and the NMI edge select bit (NMIE) in interrupt control register 0 (ICR0)

selects whether the rising edge or falling edge is detected.

Though the priority level of the NMI interrupt is 16, the NMI interrupt exception handling sets the

interrupt mask level bits (I3 to I0) in the status register (SR) to level 15.

6.4.2

User Break Interrupt

A user break interrupt which occurs when a break condition set in the user break controller (UBC)

matches has a priority level of 15. The user break exception handling sets the I3 to I0 bits in SR to

level 15. For user break interrupts, see section 7, User Break Controller (UBC).

6.4.3

H-UDI Interrupt

The user debugging interface (H-UDI) interrupt has a priority level of 15, and occurs at serial

input of an H-UDI interrupt instruction. H-UDI interrupt requests are edge-detected and retained

until they are accepted. The H-UDI exception handling sets the I3 to I0 bits in SR to level 15. For

H-UDI interrupts, see section 26, User Debugging Interface (H-UDI).

DS72011RB120FPV bảng dữ liệu(PDF) 161 Page - Renesas Technology Corp