AN4570 datasheet(41/46 Pages) STMICROELECTRONICS

41 / 46 page

DocID026804 Rev 1

41/46

AN4570

Interfacing with an 8-bit NAND Flash memory

4.4

Error correction code computation

4.4.1

Error correction code (ECC) computation overview

The FMC NAND Flash controller includes two pieces of error correction code computation

hardware, one for each NAND Flash memory block.

The ECC can be performed for page sizes of 256, 512, 1024, 2048, 4096 or 8192 bytes,

depending on the ECC page size configured by the user. Depending on the configured page

size, the ECC code will be 22, 24, 26, 28, 30 or 32 bits.

To even improve the error coverage, the user can read/write the NAND Flash page with a

reduced ECC page size. This is possible when starting and stopping the ECC computation

after the desired number of bytes to check. In this case, the ECC code is only calculated for

the bytes written and read.

The error correction code algorithm implemented in the FMC can perform 1-bit error

correction and 2-bit error detection per page read from or written to the NAND Flash

memory. It is based on the Hamming algorithm and consists in calculating the row and

column parity.

4.4.2

Error detection

Figure 12. Error detection flowchart

Program NAND page operation successful

Read ECC value during Program operation

Read written NAND page

Read new ECC value during Read operation

XOR operation between the two ECC values

All ECC bits

are zero

Yes

No error

Error detected

ai15185

AN4570 bảng dữ liệu(PDF) 41 Page - STMicroelectronics