| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
UM0851 bảng dữ liệu(PDF) 105 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
UM0851 bảng dữ liệu(HTML) 105 Page - STMicroelectronics |
|
105 / 245 page ![]() UM0851 Communication device drivers Doc ID 16604 Rev 2 105/245 4.9 CAN driver CAN is a message based protocol designed specifically for automotive applications, but now also used in other areas such as industrial automation and medical equipment. This section describes the driver for the SPEAr320 CAN controller. 4.9.1 Hardware overview Note: Available only on SPEAr320 SPEAr320 provides two independent CAN bus interfaces fully compliant to CAN 2.0 protocol specifications (both Part A and Part B) within its standard customization. The main features provided by the CAN IP are listed below: ● Bit rates up to 1 MBit/s ● 32 Message objects ● Each Message object has its own identifier mask ● Programmable FIFO mode (concatenation of message objects) ● Maskable interrupt ● Disabled automatic retransmission mode for time triggered CAN applications ● Programmable loop-back mode for self-test operation CAN IPs in SPEAr support the following test modes. The test mode is entered by setting bit test in the CAN control register to one. In test mode, the bits Tx1, Tx0, LBack, Silent and Basic in the test register are writable: ● Silent mode – In this mode, the IP is able to receive valid data frames and valid remote frames, but it sends only recessive bits on the CAN bus and it cannot start a transmission. – It can be used to analyze the traffic on a CAN bus without affecting it by the transmission of dominant bits (acknowledge bits, error frames). ● Loopback mode – In loop back mode, the CAN core treats its own transmitted messages as received messages and stores them (if they pass acceptance filtering) into a receive buffer. ● Loopback combined with silent mode This mode can be used for a "hot self test", meaning the CAN IP can be tested without affecting a running CAN system connected to the pins CAN_TX and CAN_RX. ● Basic mode In this mode the CAN IP runs without the Message RAM. Note: For further details please refer to SPEAr320 user manual |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |