| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
MPC8569E bảng dữ liệu(PDF) 111 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
MPC8569E bảng dữ liệu(HTML) 111 Page - Freescale Semiconductor, Inc |
|
111 / 127 page ![]() Programmable Interrupt Controller (PIC) MPC8569E PowerQUICC III Integrated Processor Hardware Specifications, Rev. 1 Freescale Semiconductor 111 2.17.2 Timers AC Timing Specifications The following table provides the timers input and output AC timing specifications. The following figure provides the AC test load for the timers. Figure 63. Timers AC Test Load 2.18 Programmable Interrupt Controller (PIC) This section describes the DC and AC electrical specifications for the PIC of the MPC8569E. 2.18.1 PIC DC Electrical Characteristics The following table provides the DC electrical characteristics for the external interrupt pins IRQ[0:6], IRQ[8:11] and IRQ_OUT of the PIC, as well as the port interrupts of the QUICC Engine block. Table 71. Timers Input AC Timing Specifications For recommended operating conditions, see Table 3 Parameter Symbol Typ Unit Notes Timers inputs—minimum pulse width tTIWID 20 ns 1, 2 Notes: 1. Input specifications are measured from the 50% level of the signal to the 50% level of the rising edge of CLKIN. Timings are measured at the pin. 2. Timers inputs and outputs are asynchronous to any visible clock. Timers outputs must be synchronized before use by any external synchronous logic. Timers inputs are required to be valid for at least tTIWID ns to ensure proper operation. Table 72. PIC DC Electrical Characteristics For recommended operating conditions, see Table 3 Parameter Symbol Min Max Unit Notes Input high voltage VIH 2— V 1 Input low voltage VIL —0.8 V 1 Input current (OVIN = 0 V or OVIN = OVDD)IIN —±40 μA2 Output high voltage (OVDD = min, IOH = –2 mA) VOH 2.4 — V — Output low voltage (OVDD = min, IOL = 2 mA) VOL —0.4 V — Note: 1. The min VILand max VIH values are based on the respective min and max OVIN values found in Table 3. 2. The symbol OVIN represents the input voltage of the supply. It is referenced in Table 3. Output Z0 = 50 Ω OVDD/2 RL = 50 Ω |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |