WM8510GEDSSLASHV datasheet(26/81 Pages) WOLFSON

tên linh kiện	WM8510GEDS/V

Giải thích chi tiết về linh kiện	Mono CODEC with Speaker Driver

PDF	81 Pages

Scroll/Zoom	100%

nhà sản xuất	WOLFSON [Wolfson Microelectronics plc]

Trang chủ	http://www.wolfsonmicro.com

Logo

26 / 81 page

WM8510

Production Data

PD Rev 4.1 December 2006

LIMITER MODE

In limiter mode, the ALC will reduce peaks that go above the threshold level, but will not increase the

PGA gain beyond the starting level. The starting level is the PGA gain setting when the ALC is

enabled in limiter mode. If the ALC is started in limiter mode, this is the gain setting of the PGA at

start-up. If the ALC is switched into limiter mode after running in ALC mode, the starting gain will be

the gain at switchover. The diagram below shows an example of limiter mode.

Figure 12 ALC Limiter Mode Operation

ATTACK AND DECAY TIMES

The attack and decay times set the update times for the PGA gain. The attack time is the time

constant used when the gain is reducing. The decay time is the time constant used when the gain is

increasing. In limiter mode, the time constants are faster than in ALC mode. The time constants are

shown below in terms of a single gain step, a change of 6dB and a change of 90% of the PGAs gain

range.

Note that, these times will vary slightly depending on the sample rate used (specified by the SR

WM8510GEDS/V bảng dữ liệu(PDF) 26 Page - Wolfson Microelectronics plc