WM8510GEDSSLASHV datasheet(46/81 Pages) WOLFSON

46 / 81 page

WM8510

Production Data

PD Rev 4.1 December 2006

HEADPHONE OUTPUT

The speaker outputs can drive a 16

Ω or 32Ω headphone load, either through DC blocking capacitors,

or DC coupled without any capacitor.

Headphone Output using DC Blocking Capacitors:

DC Coupled Headphone Output:

Figure 23 Recommended Headphone Output Configurations

When DC blocking capacitors are used, then their capacitance and the load resistance together

determine the lower cut-off frequency, fc. Increasing the capacitance lowers fc, improving the bass

response. Smaller capacitance values will diminish the bass response. Assuming a 16

Ω load and

C1, C2 = 220

µF:

fc = 1 / 2

π RLC1 = 1 / (2π x 16Ω x 220µF) = 45 Hz

In the DC coupled configuration, the headphone “ground” is connected to the MONOOUT pin. The

MONOOUT pin can be configured as a DC output driver by setting the MONOMUTE register bit. The

DC voltage on MONOOUT in this configuration is equal to the DC offset on the SPKOUTP and

SPKOUTN pins therefore no DC blocking capacitors are required. This saves space and material

cost in portable applications.

It is recommended to connect the DC coupled outputs only to headphones, and not to the line input

of another device. Although the built-in short circuit protection will prevent any damage to the

headphone outputs, such a connection may be noisy, and may not function properly if the other

device is grounded.

MONO OUTPUT

The mono output, can be used as a line output, a headphone output or as a pseudo ground for cap-

less driving of loads by SPKOUT. Recommended external components are shown below.

Figure 24 Recommended Circuit for Line Output

The DC blocking capacitors and the load resistance together determine the lower cut-off frequency,

fc. Assuming a 10 k

Ω load and C1 = 1µF:

fc = 1 / 2

π (RL+R1) C1 = 1 / (2π x 10.1kΩ x 1µF) = 16 Hz

Increasing the capacitance lowers fc, improving the bass response. Smaller values of C1 will diminish

the bass response. The function of R1 is to protect the line outputs from damage when used

improperly.

WM8510GEDS/V bảng dữ liệu(PDF) 46 Page - Wolfson Microelectronics plc