SSD1963QL9R datasheet(43/93 Pages) ETC2

43 / 93 page

SSD1963

Rev 1.1

P 43/93

Jan 2010

Solomon Systech

9.30 set_tear_scanline

Command

0x44

Parameters

D/C

Hex

Command

Parameter 1

N15

N14

N13

N12

N11

N10

Parameter 2

Description

TE signal is sent from the SSD1963 to the host processor when the display panel refresh reaches the provided scanline,

N[15:8] : High byte of the scanline (POR = 00000000)

N[7:0] : Low byte of the scanline (POR = 00000000)

Note :

Set Tear Scanline with N = 0 is equivalent to set_tear_on (0x35) A[0] = 0.

This command takes affect on the frame following the current frame. Therefore, if the Tear Effect (TE) signal is already

ON, the TE output shall continue to operate as programmed by the previous set_tear_on (0x35) or set_tear_scanline

(0x44) until the end of the frame.

9.31 get_scanline

Command

0x45

Parameters

D/C

Hex

Command

Parameter 1

N15

N14

N13

N12

N11

N10

Parameter 2

Description

Get the current scan line, N.

N[15:8] : High byte of the current scanline (POR = 00000000)

N[7:0] : Low byte of the current scanline (POR = 00000000)

SSD1963QL9R bảng dữ liệu(PDF) 43 Page - List of Unclassifed Manufacturers

SSD1963QL9R bảng dữ liệu(HTML) 43 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93

bảng dữ liệu tải về

Link URL