| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
DSP56857 bảng dữ liệu(PDF) 279 Page - Freescale Semiconductor, Inc |
|
|
|||||||||||||||||||||||||||||
DSP56857 bảng dữ liệu(HTML) 279 Page - Freescale Semiconductor, Inc |
|
279 / 662 page ![]() Operating Modes Serial Peripheral Interface (SPI), Rev. 4 Freescale Semiconductor 11-9 When the master SPI starts a transmission, the data in the slave Shift register begins shifting out on the MISO pin. The slave can load its Shift register with new data for the next transmission by writing to its Transmit Data register. The slave must write to its Transmit Data register at least one bus cycle before the master begins the next transmission. Otherwise, the data already in the slave Shift register shifts out on the MISO pin. Data written to the Slave Shift register during a transmission remains in a buffer until the end of the transmission. When the CPHA bit is set, the first edge of SCLK starts a transmission. When CPHA is cleared, the falling edge of SS starts a transmission. Note: SCLK must be in the proper idle state before the slave is enabled to prevent SCLK from appearing as a clock edge. 11.6.3 DMA Mode When the TDMAEN or RDMAEM bits are set, the SPI operates in DMA mode. Normal SPTE and/or SPRF interrupts are suppressed. Instead DMA requests are generated, signaling the DMA controllers to read the SPDRR or SPDTR as needed. The DMA requests are suppressed in the case of an OVRF or MODF interrupt, illustrated in Figure 11-4. If the SPI is being used to send and receive data, both TDMAEN and RDMAEN should be enabled/disabled at the same time. If data is only being received or transmitted TDMAEN or RDMAEN may be left inactive as appropriate, however in this case ERRIE must not be set to prevent the DMA request being masked by a mode-fault error or overflow error. DMA mode must be used carefully. In the case where CPHA=0, the SS signal to the slave is toggled by software between words. In DMA mode there is no way of generating this pulse easily, so the DMA should not be used when CPHA=0. Figure 11-4. SPI DMA Request Generation Receive DMA Request Transmit DMA Request SPTE SPRIE MODF OVRF TDMAEN MODF OVRF ERRIE SPRF RDMAEN |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |