BLUENRG-2 datasheet(72/190 Pages) STMICROELECTRONICS

72 / 190 page

Functional details

BlueNRG-2

72/190

DocID030675 Rev 2

Required bit rate

(bps)

Programmed divisor

Generated bit rate

(bps)

Error

(%)

Integer

(DIVINT)

Fraction

(DIVFRAC)

2 400

833 (16’h0341)

21 (6’h15)

2 400

1 200

1666 (16’h0682)

43 (6’h2B)

1 199

-0.083

300

6666

(16’h1A0A)

(6’h2B)

299

-0.333

110

18181

(16’h4705)

52 (6’h34)

110

3.9.2.3

Hardware flow control

The hardware flow controls feature is fully selectable through RTSEN and CTSEN in

UARTCR register, and allows to control the serial data flow by using the UART_RTS output

and UART_CTS input signals.

Figure 14: Hardware flow control between two similar devices

When the RTS flow control is enabled, the UART_RTS signal is asserted until the receive

FIFO is filled up to the programmed watermark level. When the CTS flow control is

enabled, the transmitter can only transmit data when the UART_CTS signal is asserted.

Table 74: Control bits to enable and disable hardware flow control

CTSEN

RTSEN

Function

Both RTS and CTS flow control disabled.

Only RTS flow control enabled.

Only CTS flow control enabled.

Both RTS and CTS flow control enabled.

The RTS flow control logic is linked to the programmable receive FIFO watermark levels.

When RTS flow control is enabled, the UART_RTS is asserted until the receive FIFO is

BLUENRG-2 bảng dữ liệu(PDF) 72 Page - STMicroelectronics

BLUENRG-2 bảng dữ liệu(HTML) 72 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL