PI7C7300DNA datasheet(97/107 Pages) PERICOM

97 / 107 page

PI7C7300D

3-PORT PCI-TO-PCI BRIDGE

Page 97 of 107

Pericom Semiconductor

November 2005 - Revision 1.01

15.3.4

SECONDARY IDSEL MAPPING

When PI7C7300D detects a Type 1 configuration transaction for a device connected to

the secondary, it translates the Type 1 transaction to Type 0 transaction on the

downstream interface. Type 1 configuration format uses a 5-bit field at P_AD[15:11] as a

device number. This is translated to S1_AD[31:16] or S2_AD[31:16] by PI7C7300D.

IEEE 1149.1 COMPATIBLE JTAG CONTROLLER

An IEEE 1149.1 compatible Test Access Port (TAP) controller and associated TAP pins

are provided to support boundary scan in PI7C7300D for board-level continuity test and

diagnostics. The TAP pins assigned are TCK, TDI, TDO, TMS and TRST#. All digital

input, output, input/output pins are tested except TAP pins and clock pin.

The IEEE 1149.1 Test Logic consists of a TAP controller, an instruction register, and

a group of test data registers including Bypass, Device Identification and Boundary Scan

registers. The TAP controller is a synchronous 16-state machine driven by the Test Clock

(TCK) and the Test Mode Select (TMS) pins. An independent power on reset circuit is

provided to ensure the machine is in TEST_LOGIC_RESET state at power-up. The

JTAG signal lines are not active when the PCI resource is operating PCI bus cycles.

PI7C7300D implements 3 basic instructions: BYPASS, SAMPLE/PRELOAD, and

EXTEST.

16.1

BOUNDARY SCAN ARCHITECTURE

Boundary-scan test logic consists of a boundary-scan register and support logic. These

are accessed through a Test Access Port (TAP). The TAP provides a simple serial

interface that allows all processor signal pins to be driven and/or sampled, thereby

providing direct control and monitoring of processor pins at the system level.

This mode of operation is valuable for design debugging and fault diagnosis since it

permits examination of connections not normally accessible to the test system. The

following subsections describe the boundary-scan test logic elements: TAP pins,

instruction register, test data registers and TAP controller. Error! Reference source not

found. illustrates how these pieces fit together to form the JTAG unit.

PI7C7300DNA bảng dữ liệu(PDF) 97 Page - Pericom Semiconductor Corporation