HD64F2149YV datasheet(210/1075 Pages) RENESAS

tên linh kiện	HD64F2149YV

Giải thích chi tiết về linh kiện	Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2100 Series

PDF	1075 Pages

Scroll/Zoom	100%

nhà sản xuất	RENESAS [Renesas Technology Corp]

Trang chủ	http://www.renesas.com

Logo

210 / 1075 page

Section 7 Data Transfer Controller

Rev. 3.00 Jan 18, 2006 page 182 of 1044

REJ09B0280-0300

7.3.3

DTC Vector Table

Figure 7.4 shows the correspondence between DTC vector addresses and register information.

Table 7.4 shows the correspondence between activation sources, vector addresses, and DTCER

bits. When the DTC is activated by software, the vector address is obtained from: H'0400 +

DTVECR[6:0] << 1 (where << 1 indicates a 1-bit left shift). For example, if DTVECR is H'10, the

vector address is H'0420.

The DTC reads the start address of the register information from the vector address set for each

activation source, and then reads the register information from that start address. The register

information can be placed at predetermined addresses in the on-chip RAM. The start address of

the register information should be an integral multiple of four.

The configuration of the vector address is the same in both normal and advanced modes, a 2-byte

unit being used in both cases. These two bytes specify the lower bits of the address in the on-chip

RAM.

start address

Chain transfer

DTC vector

address

Figure 7.4 Correspondence between DTC Vector Address and Register Information

HD64F2149YV bảng dữ liệu(PDF) 210 Page - Renesas Technology Corp