PRT2011CVL5A datasheet(35/112 Pages) NXP

35 / 112 page

Electrical Characteristics

i.MX RT1064 Crossover Processors Data Sheet for Consumer Products, Rev. 2, 08/2020

NXP Semiconductors

Figure 4. Load circuit for output

Figure 5. Output transition time waveform

4.3.2.1

General purpose I/O AC parameters

The I/O AC parameters for GPIO in slow and fast modes are presented in the Table 24 and Table 25,

respectively. Note that the fast or slow I/O behavior is determined by the appropriate control bits in the

IOMUXC control registers.

Table 24. General purpose I/O AC parameters 1.8 V mode

Parameter

Symbol

Test Condition

Min

Typ

Max

Unit

Output Pad Transition Times, rise/fall

(Max Drive, ipp_dse=111)

tr, tf

15 pF Cload, slow slew rate

15 pF Cload, fast slew rate

——

2.72/2.79

1.51/1.54

Output Pad Transition Times, rise/fall

(High Drive, ipp_dse=101)

tr, tf

15 pF Cload, slow slew rate

15 pF Cload, fast slew rate

——

3.20/3.36

1.96/2.07

Output Pad Transition Times, rise/fall

(Medium Drive, ipp_dse=100)

tr, tf

15 pF Cload, slow slew rate

15 pF Cload, fast slew rate

——

3.64/3.88

2.27/2.53

Output Pad Transition Times, rise/fall

(Low Drive. ipp_dse=011)

tr, tf

15 pF Cload, slow slew rate

15 pF Cload, fast slew rate

——

4.32/4.50

3.16/3.17

Input Transition Times1

1 Hysteresis mode is recommended for inputs with transition times greater than 25 ns.

trm

—

Test Point

From Output

Under Test

CL includes package, probe and fixture capacitance

OVDD

20%

80%

20%

Output (at pad)

PRT2011CVL5A bảng dữ liệu(PDF) 35 Page - NXP Semiconductors

PRT2011CVL5A bảng dữ liệu(HTML) 35 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL