| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
MC68HC908AP16CFB bảng dữ liệu(PDF) 91 Page - Motorola, Inc |
|
|
|||||||||||||||||||||||||||||
MC68HC908AP16CFB bảng dữ liệu(HTML) 91 Page - Motorola, Inc |
|
91 / 440 page ![]() MC68HC908AP Family — Rev. 2.5 Data Sheet MOTOROLA 91 Data Sheet – MC68HC908AP Family Section 7. Oscillator (OSC) 7.1 Introduction The oscillator module consist of three types of oscillator circuits: • Internal oscillator • RC oscillator • 32.768kHz crystal (x-tal) oscillator The reference clock for the CGM and other MCU sub-systems is selected by programming the mask option register located at $FFCF. The reference clock for the timebase module (TBM) is selected by the two bits, OSCCLK1 and OSCCLK0, in the CONFIG2 register. The internal oscillator runs continuously after a POR or reset, and is always available. The RC and crystal oscillator cannot run concurrently; one is disabled while the other is selected; because the RC and x-tal circuits share the same OSC1 pin. NOTE: The oscillator circuits are powered by the on-chip VREG regulator, therefore, the output swing on OSC1 and OSC2 is from VSS to VREG. Figure 7-1. shows the block diagram of the oscillator module. Freescale Semiconductor, Inc. For More Information On This Product, Go to: www.freescale.com |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |