RM0319 datasheet(171/368 Pages) STMICROELECTRONICS

171 / 368 page

RM0319

Fast Ethernet ports (RMII0/RMII1/MII1)

Doc ID 022640 Rev 3

171/368

To receive all multicast frames, the hash register should be set with all ones and the

multicast hash enable bit should be set in the network configuration register.

External address matching

As an alternative to using the built in frame filtering functionality, a user may implement their

own external frame filtering block.The external address input signal (eam) is provided for

this purpose and enabled by bit 9 in the network configuration register.

If the eam signal is asserted before 16 bytes have been received the frame will be copied to

memory.

Copy all frames (or Promiscuous Mode)

If the copy all frames bit is set in the network configuration register then all non-errored

frames will be copied to memory. For example, frames that are too long, too short, have FCS

errors or have rx_er asserted during reception will be discarded and all others will be

received. Frames with FCS errors are copied to memory if bit 19 in the network

configuration register is set.

Type ID checking

The contents of the type_id register are compared against the length/type ID of received

frames (that is. bytes 13 and 14). Bit 22 in the receive buffer descriptor status is set if there

is a match. The reset state of this register is zero which is unlikely to match the length/type

ID of any valid Ethernet frame.

Note:

A type ID match does not affect whether a frame is copied to memory.

VLAN support

An Ethernet encoded 802.1Q VLAN tag looks like this.

The VLAN tag is inserted at the 13th byte of the frame adding an extra four bytes to the

frame.

If the VID (VLAN identifier) is null (0x000) this indicates a priority-tagged frame.

The MAC can support frame lengths up to 1536 bytes, 18 bytes more than the original.

Ethernet has a maximum frame length of 1518 bytes. This is achieved by setting bit 8 in the

network configuration register.

The following bits in the receive buffer descriptor status word give information about VLAN

tagged frames:-

●

Bit 21 set if receive frame is VLAN tagged (that is. type id of 0x8100)

●

Bit 20 set if receive frame is priority tagged (that is. type id of 0x8100 and null VID). (If

bit 20 is set bit 21 will be set also.)

●

Bit 19, 18 and 17 set to priority if bit 21 is set

●

Bit 16 set to CFI if bit 21 is set

TPID (Tag Protocol Identifier) 16 bits

TCI (Tag Control Information) 16 bits

0x8100

First 3 bits priority, then CFI bit, last 12 bits VID

RM0319 bảng dữ liệu(PDF) 171 Page - STMicroelectronics

RM0319 bảng dữ liệu(HTML) 171 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL