M95M02-DRMN6TP datasheet(27/41 Pages) STMICROELECTRONICS

tên linh kiện	M95M02-DRMN6TP

Giải thích chi tiết về linh kiện	2-Mbit serial SPI bus EEPROM

PDF	41 Pages

Scroll/Zoom	100%

nhà sản xuất	STMICROELECTRONICS [STMicroelectronics]

Trang chủ	http://www.st.com

Logo

27 / 41 page

DocID18203 Rev 8

27/41

M95M02-DR

Instructions

6.9

Read Lock Status

The Read Lock Status instruction (see Table 3) is used to check whether the Identification

Page is locked or not in Read-only mode. The Read Lock Status sequence is defined with

the Chip Select (S) first driven low. The bits of the instruction byte and address bytes are

then shifted in on Serial Data Input (D). Address bit A10 must be 1, all other address bits are

Don't Care. The Lock bit is the LSB (least significant bit) of the byte read on Serial Data

Output (Q). It is at “1” when the lock is active and at “0” when the lock is not active. If Chip

Select (S) continues to be driven low, the same data byte is shifted out. The read cycle is

terminated by driving Chip Select (S) high.

The instruction sequence is shown in Figure 17.

Figure 17. Read Lock Status sequence

MS30910V1

9 10

28 29 30 31 32 33 34 35

3210

36 37 38

76543

High impedance

Data Out 1

Instruction

24-bit address

MSB

Data Out 2

23 22 21

M95M02-DRMN6TP bảng dữ liệu(PDF) 27 Page - STMicroelectronics