PIC18F44J10 datasheet(45/368 Pages) MICROCHIP

45 / 368 page

DS39682E-page 43

PIC18F45J10 FAMILY

5.2

Master Clear (MCLR)

The MCLR pin provides a method for triggering a hard

external Reset of the device. A Reset is generated by

holding the pin low. PIC18 extended microcontroller

devices have a noise filter in the MCLR Reset path

which detects and ignores small pulses.

The MCLR pin is not driven low by any internal Resets,

including the WDT.

5.3

Power-on Reset (POR)

A Power-on Reset condition is generated on-chip

whenever VDD rises above a certain threshold. This

allows the device to start in the initialized state when

VDD is adequate for operation.

To take advantage of the POR circuitry, tie the MCLR

pin through a resistor (1 k

Ω to 10 kΩ) to VDD. This will

eliminate external RC components usually needed to

create a Power-on Reset delay. A minimum rise rate for

VDD is specified (parameter D004). For a slow rise

time, see Figure 5-2.

When the device starts normal operation (i.e., exits the

Reset

condition),

device

operating

parameters

(voltage, frequency, temperature, etc.) must be met to

ensure operation. If these conditions are not met, the

device must be held in Reset until the operating

conditions are met.

Power-on Reset events are captured by the POR bit

(RCON<1>). The state of the bit is set to ‘0’ whenever

a Power-on Reset occurs; it does not change for any

other Reset event. POR is not reset to ‘1’ by any

hardware event. To capture multiple events, the user

manually resets the bit to ‘1’ in software following any

Power-on Reset.

5.4

Brown-out Reset (BOR)

(PIC18F2XJ10/4XJ10 Devices Only)

The PIC18F45J10 family of devices incorporates a

simple BOR function when the internal regulator is

enabled (ENVREG pin is tied to VDD). Any drop of VDD

below VBOR (parameter D005) for greater than time

TBOR (parameter 35) will reset the device. A Reset may

or may not occur if VDD falls below VBOR for less than

TBOR. The chip will remain in Brown-out Reset until

VDD rises above VBOR.

Once a BOR has occurred, the Power-up Timer will

keep the chip in Reset for TPWRT (parameter 33). If

VDD drops below VBOR while the Power-up Timer is

running, the chip will go back into a Brown-out Reset

and the Power-up Timer will be initialized. Once VDD

rises above VBOR, the Power-up Timer will execute the

additional time delay.

FIGURE 5-2:

EXTERNAL POWER-ON

RESET CIRCUIT (FOR

SLOW VDD POWER-UP)

5.4.1

DETECTING BOR

The BOR bit always resets to ‘0’ on any Brown-out

Reset or Power-on Reset event. This makes it difficult

to determine if a Brown-out Reset event has occurred

just by reading the state of BOR alone. A more reliable

method is to simultaneously check the state of both

POR and BOR. This assumes that the POR bit is reset

to ‘1’ in software immediately after any Power-on Reset

event. If BOR is ‘0’ while POR is ‘1’, it can be reliably

assumed that a Brown-out Reset event has occurred.

In devices designated with an “LF” part number (such

as PIC18LF25J10), Brown-out Reset functionality is

disabled. In this case, the BOR bit cannot be used to

determine a Brown-out Reset event. The BOR bit is still

cleared by a Power-on Reset event.

Note 1:

External Power-on Reset circuit is required

only if the VDD power-up slope is too slow.

The diode D helps discharge the capacitor

quickly when VDD powers down.

R < 40 k

Ω is recommended to make sure that

the voltage drop across R does not violate

the device’s electrical specification.

≥ 1 kΩ will limit any current flowing into

MCLR from external capacitor C, in the event

of MCLR pin breakdown, due to Electrostatic

Discharge (ESD) or Electrical Overstress

(EOS).

VDD

MCLR

PIC18F45J10

VDD

PIC18F44J10 bảng dữ liệu(PDF) 45 Page - Microchip Technology

PIC18F44J10 bảng dữ liệu(HTML) 45 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL