TCM4400EPET datasheet(39/64 Pages) TI

39 / 64 page

TCM4400E

GSM/DCS BASEBAND AND VOICE A/D

AND D/A RF INTERFACE CIRCUIT

SLWS082A – JULY 1999 – REVISED MARCH 2000

POST OFFICE BOX 655303

• DALLAS, TEXAS 75265

PRINCIPLES OF OPERATION

DSP voiceband serial interface

Voiceband serial digital interface consists of a bidirectional serial port. Both receive and transmit operations are

double buffered, thus allowing a continuous communication stream. The serial port is fully static and, thus,

functions with any arbitrary low-clocking frequency.

The transfer mode available on this port is:

Clock frequency

520 kHz

16-bit data packet

frame synchronization

VCLK is the output serial clock used to control the transmission or reception of the data, (see Figure 5). VCLK

can run in burst mode or continuous mode, depending on the VCLKMODE bit. The transmitted serial data (VDX)

is the serial data output; the frame synchronization (VFS) is used to initiate the transfer of transmit and receive

data. The received data (VDR) is the serial data input.

Each serial port includes four registers: the data transmit register (DXR), the data receive register (DRR), the

transmit shift register (XSR), and the receive shift register (RSR).

The voice serial interface has the same structure and timing diagram as the serial interface. One extra cycle

is generated before VFS, and two extra cycles are generated after the least significant bit (see Figure 5).

TCM4400EPET bảng dữ liệu(PDF) 39 Page - Texas Instruments