HD64F2149YV datasheet(157/1075 Pages) RENESAS

157 / 1075 page

Section 5 Interrupt Controller

Rev. 3.00 Jan 18, 2006 page 129 of 1044

REJ09B0280-0300

5.5.3

Interrupt Control Mode 1

Three-level masking is implemented for IRQ interrupts and on-chip supporting module interrupts

by means of the I and UI bits in the CPU’s CCR, and ICR.

• Control level 0 interrupt requests are enabled when the I bit is cleared to 0, and disabled when

set to 1.

• Control level 1 interrupt requests are enabled when the I bit or UI bit is cleared to 0, and

disabled when both the I bit and the UI bit are set to 1.

For example, if the interrupt enable bit for an interrupt request is set to 1, and H'20, H'00, and H'00

are set in ICRA, ICRB, and ICRC, respectively, (i.e. IRQ2 and IRQ3 interrupts are set to control

level 1 and other interrupts to control level 0), the situation is as follows:

• When I = 0, all interrupts are enabled

(Priority order: NMI > IRQ2 > IRQ3 > address break > IRQ0 > IRQ1 ...)

• When I = 1 and UI = 0, only NMI, IRQ2, IRQ3 and address break interrupts are enabled

• When I = 1 and UI = 1, only NMI and address break interrupts are enabled

Figure 5.9 shows the state transitions in these cases.

Only NMI and address break

interrupts enabled

All interrupts enabled

Exception handling execution

or I

←1, UI←1

←0

←1, UI←0

←0UI←0

Exception handling execution

or UI

←1

Only NMI, address break, IRQ2,

and IRQ3 interrupts enabled

Figure 5.9 Example of State Transitions in Interrupt Control Mode 1

HD64F2149YV bảng dữ liệu(PDF) 157 Page - Renesas Technology Corp