| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
C511 bảng dữ liệu(PDF) 31 Page - Siemens Semiconductor Group |
|
|
|||||||||||||||||||||||||||||
C511 bảng dữ liệu(HTML) 31 Page - Siemens Semiconductor Group |
|
31 / 128 page ![]() Semiconductor Group 4-4 External Bus Interface can be enabled/disabled dynamically, it is also possible to enable ALE only when external memory is accessed. This can be useful, if the external memory is accessed very seldom only. 4.4 XRAM Access Enable (SAB-C513A/A-H only) The SAB-C513A/A-H maps 256 bytes of the external data space into the on-chip XRAM. Especially when using the 8-bit addressing modes this could prevent access to the external memory extension and might induce problems when porting software. Therefore it is possible to enable and disable the on-chip XRAM. When the XRAM is disabled (default after reset) all accesses will go to the external memory/IO. Special Function Registers SYSCON (Address B1H) Reset Value (C513/513A/A-H) : 101X0XX0B Reset Value (C511/C511A/C513) : 101X0XXXB 4.5 Overlapping External Data and Program Memory Spaces In some applications it is desirable to execute a program from the same physical memory that is used for storing data. In the SAB-C511/C513 the external program and data memory spaces can be combined by AND-ing PSEN and RD. A positive logic AND of these two signals produces an active low read strobe that can be used for the combined physical memory. Since the PSEN cycle is faster than the RD cycle, the external memory needs to be fast enough to adapt to the PSEN cycle. Bit Function – Not implemented. Reserved for future use. 7, 6, 3 Reserved bits; these bits must be always written with the values shown above. XMAP Enable XRAM (SAB-C513A/A-H only). XMAP=0 : XRAM disabled. XMAP=1 : XRAM enabled. Note: This bit is don’t care for the other members of the SAB-C511/513 family, but should be written with “0“ for compatibility reasons when writing to the SYSCON register. When reading the bit in non-SAB-C513A versions, it will be undefined. EALE Enable ALE generation. If EALE=0, ALE signal will not be generated. If EALE=1, ALE signal will be generated. 1 0 EALE – B1H SYSCON Bit No. 7 65 43 21 0 MSB LSB 0– – XMAP |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |