F39-TGR-CVL-B-2-R datasheet(94/98 Pages) OMRON

94 / 98 page

FAQ

Section 17-6

17-6 FAQ

17-6-1 How do you initiate Fixed Blanking with the MS4800?

Fixed Blanking:

• Selecting Fixed Blanking with selector switches

Please place the obstruction in your wished detection zone and the receiv-

er goes into the Machine Stop state.

Please activate Fixed Blanking (both nr. 5 switches to on) and the system

enters a fault state.

The Power Supply must be deactivated and immediately activated. The

MS4800 will be now in the Fixed Blanking mode and the red as well as the

amber LEDs will lit.

Please deactivate Fixed Blanking (both nr. 5 switches to off).

Please activate Fixed Blanking (both nr. 5 switches to on) and the Program

switch is activated (red and amber LED will flash).

In order to program a pattern you have to flip the Program switch once (Se-

lector SW A nr. 6 from on/off or off/on).

The Power Supply must be deactivated and immediately activated.

If all settings are correct now the system enters the Interlock or Machine

Run state.

For deleting this mode please switch both nr. 5 selectors to the off mode

and deactivate the Power Supply.

Note During programming a pattern you have a 10min time limit before you have to

repeat your settings.

17-6-2 How do you initiate Floating Blanking with the MS4800?

Floating Blanking:

• Selecting Floating Blanking with selector switches

Please activate Floating Blanking (both nr. 4 switches to on).

The Power Supply must be deactivated and immediately activated.

Floating is now activated and one object can freely float from one end of

the protective field to the other without entering the Machine Stop state

Note Two-Beam Floating Blanking or more is not available on the MS4800 Series

17-6-3 How do you remove cascaded segments?

Segment Reduction Restart Procedure:

Turn ON the power supply of the SLC, the start button must be pressed for

app. 3 seconds until all status LEDs of the receiver MS4800 system are

flashing shortly.

While the status LEDs are flashing, release the start button.

The MS4800 system performs a system reboot. When this sequence is

properly completed, the error code "100" is cleared and the MS4800 sys-

tem is ready to operate in normal state.

F39-TGR-CVL-B-2-R bảng dữ liệu(PDF) 94 Page - Omron Electronics LLC

F39-TGR-CVL-B-2-R bảng dữ liệu(HTML) 94 Page - Omron Electronics LLC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98

bảng dữ liệu tải về

Link URL