OX16CF950 datasheet(17/60 Pages) ETC

17 / 60 page

Page 17

OXCF950 DATA SHEET V1.1

OXFORD SEMICONDUCTOR LTD.

If a PCMCIA/CF card is using the I/O interface and this field is reset to zero (0),

the function shall not assert STSCHG#.

If a PCMCIA/CF card is not using the I/O interface or the function’s Pin

Replacement register is not present, this field is undefined and should be

ignored.

IOIs8

R/W

The host sets this field to one (1) when it can provide I/O cycles only with an 8-bit

D[7..0] data path. The card is guaranteed that accesses to the 16-bit registers will

occur as two byte accesses rather than as a single 16-bit access.

RFU

Reserved. Must be zero (0).

Audio2

R/W

This bit is set to one (1) to enable audio information on SPKR# when the card is

configured.

PwdDwn3

R/W

When the host sets this field to one (1), the function shall enter a power-down

state, if such a state exists.

If a PCMCIA/CF card function does not have a power-down state, the function

shall ignore this field.

Intr

Interrupt Request / Acknowledge – This field reports whether the function is

requesting interrupt servicing and may be used to acknowledge the host system

is ready to process another interrupt request from the PCMCIA/CF card.

The function shall set this field to one (1) when it is requesting interrupt service.

The function shall set this field to zero (0) when it is not requesting interrupt

service.

Writes to this field are ignored when the IntrAck field of all Configuration and

Status Registers on the PCMCIA/CF card are reset to zero (0).

IntrAck

R/W

Single function cards ignore this field on writes and always return zero (0).

Table 15: Configuration Status Register

Note 1

The STSCHG# signal is optional and is not supported on the OXCF950, to reduce the complexity of the device.

Note 2

Audio is not supported on the device.

Note 3

The OXCF950 does not support a specific power down mode, since it is a low power device that features a number of sleep

modes (see Section 7 for further details).

5.5.3

Pin Replacement Register ‘PRR’ (Offset 0xFC)

The Pin Replacement Register is implemented to provide information about READY, WP or the BVD[2..1] status when

implementing the I/O interface.

CBVD1

CBVD2

CREADY

CWProt

RBVD1

RBVD2

RREADY

RWProt

Field

Description

CBVD1

This bit is set (1) when the corresponding bit, RBVD1, changes state. This bit may also be

written by the host.

CBVD2

This bit is set (1) when the corresponding bit, RBVD2, changes state. This bit may also be

written by the host.

OX16CF950 bảng dữ liệu(PDF) 17 Page - List of Unclassifed Manufacturers

OX16CF950 bảng dữ liệu(HTML) 17 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

bảng dữ liệu tải về

Link URL