DM330023-2 datasheet(24/64 Pages) MICROCHIP

24 / 64 page

dsPICDEM™ MCHV Development System User’s Guide

DS70605A-page 18

 2009 Microchip Technology Inc.

3. Connect the communication ports.

a) If R-S32 communication is used, connect the DB9 male connector to the

RS-232 port. Connect the other end to the host PC (12 in Figure 2-5).

b) If USB communication is used, connect the mini-USB male terminal to the

mini-USB female connector labeled “USB” (12 in Figure 2-5). Connect the

other end to the host PC.

4. Connect the SKDE cable. Connect the USB cable to the mini USB female

connector labeled “Program/Debug” (14 in Figure 2-5). Connect the USB male

terminal to the USB ports of the host PC.

5. Power Cord connection. Make sure the power cord is disconnected from the AC

mains before connecting the female terminal of the power cable to the AC input

connector (1, 2, and 3 in Figure 2-53) of the dsPICDEM™ MCHV Development

System.

Note: The Microchip serial emulator driver (mchpcdc.inf) should be installed on

you PC in order to activate the USB-to-Serial emulator. The emulator driver

is contained in the CD shipped with the dsPICDEM™ MCHV Development

System.

Note: The built-in programmer/debugger is supported in MPLAB IDE 8.33 or

higher.

Note: The unit is designed to be connected to the AC mains supply via a standard

non-locking plug. As the unit has no mains switch, this plug constitutes the

means of disconnection from the supply. Therefore, the user must have

unobstructed access to this plug during operation.

DM330023-2 bảng dữ liệu(PDF) 24 Page - Microchip Technology