822-1002-C01 datasheet(14/40 Pages) MAGNETROL

14 / 40 page

The microprocessor-based Sentinel offers all operator func-

tions and setup procedures from the three tactile-feedback

keys described above. Due to the number of user program-

mable features included in the unit, the calibration flow

chart is extensive. The flow chart is modular, however, it

can be divided into five subsections or program paths

which are connected to a home base, or normal operating

mode, RUN (walking M or S). When letters scroll horizon-

tally across the LED and no error messages are displayed,

all systems are functioning properly. The calibration flow

chart structure is shown on page 12.

NOTE: If MagneCal precalibration data was entered at the

factory, use Advanced Calibration procedures (Section 2.5) in

conjunction with the standard calibration procedures.

2.2

Program Paths

In order to properly calibrate the Sentinel, the Calibration

instructions are broken down into the five PATHS

described below.

Access to program paths is granted with the following

key strokes:

Configuration

Press ENT

and UP

arrow keys

simultaneously (

)

Single Point

Press ENT

Probe Calibration

Press UP

and DOWN

arrow keys

simultaneously (

)

NOTE: This procedure MUST be performed if Multi-Point mode

is selected.

Multi-Point

Press ENT

Service

Press ENT

and DOWN

arrow keys

simultaneously (

)

NOTE: At any given time during user configuration, pressing the

ENT

, UP

, and DOWN

arrow keys simultaneously

(

) will escape from any location and return to RUN.

ENT

50-621 Kotron Sentinel Models 822, 832 and 842 RF Point Level Switches

Configuration

Multi-Point

Service

Probe

Calibration

Single Point

822-1002-C01 bảng dữ liệu(PDF) 14 Page - Magnetrol International, Inc.

822-1002-C01 bảng dữ liệu(HTML) 14 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40

bảng dữ liệu tải về

Link URL