AS3525 datasheet(24/194 Pages) AMSCO

24 / 194 page

AS3525-A/-B C22O22

Data Sheet, Confidential

www.austriamicrosystems.com

Revision 1.13

- 194

7.2 AHB Peripheral Blocks

ARM AHB ("advanced high-performance bus") is the new generation of AMBA bus, which is intended to address the requirements of high-

performance synthesizable designs. AMBA AHB implements the features required for high performance, high clock frequency systems including:

•

burst transfers

•

split transactions

•

single cycle bus master handover

•

non-tristate implementation

•

32 bit bus width

•

the clock frequency of the AHB can set by software up to 65MHz

7.2.1 2.5 MBIT RAM Main Memory

The memory subsystem consists of a RAM part and a ROM part.

Within the RAM memory subsystem, following functions are included:

•

1-TRAM controller with AHB bus slave interface

•

1-TRAM memory macros

7.2.1.1 1-TRAM Controller

The 1T RAM Controller is a slave interface connected to the AMBA AHB bus.

•

slave AHB interface

•

supports byte(8 bit), half-word(16 bit) and word(32 bit) read/write accesses

•

128-bit Line Buffer as temporary storage to reduce the number of memory accesses and optimise power

consumption

•

controls 5TSMC 1T-RAM instances

7.2.1.2 On-Chip 1T-RAM macro blocks

TSMC Emb1tRAM

™ technology is a special kind of DRAM, which is implemented in a logic CMOS process. This innovative concept and design

guarantees lowest power, high density, high performance and high yield advantages.

ECC (Error Correction Code) technique is applied in the macro to dynamically correct errors caused by hard defects or soft errors. No fuses are

needed because the conventional redundancy scheme is replaced with ECC design in the macro.

The macro can be operated at clock rate from 20 MHz up to maximum AHB bus clock frequency in flow through random access mode. In the

product, one idle cycle for refresh is needed in every 32 clock cycles.

Total 5 macros with organisation of 4Kx128 = 64 KByte each are implemented. For the refresh, one master macro is generating the refresh clock

(T1F4Kx128_PIFE) and four macros are connected serially in slave mode to the refresh clock (T1F4Kx128PIFES).

Features

•

20 Mhz to 65 Mhz operation speed

•

Flow through random access

•

Built-in error correction (ECC)

•

128-bit wide data bus

•

Separated data in/out bus

•

SRAM-style interface operation

•

Built-in refresh controller with refresh clock generator

AS3525 bảng dữ liệu(PDF) 24 Page - ams AG

AS3525 bảng dữ liệu(HTML) 24 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL