AS3525 datasheet(92/194 Pages) AMSCO

92 / 194 page

AS3525-A/-B C22O22

Data Sheet, Confidential

www.austriamicrosystems.com

Revision 1.13

- 194

7.3.12.7 Clock frequencies

The input clock is directly taken from the PCLK clock. A programmable prescaler is implemented within the CGU. Input clock for the prescaler is in

the range of 20 - 60 MHz.

Programmable division factors for the prescaler in the range of 1 to 8. Input clock to the module is in the range of 2.5 to 60 MHz.

Within the module the control signal generator is doing a division by 16 or 32 (selectable). So the effective output data rates are in the range of 1.25

to 4 MHz for maximum performance and can be scaled down in the range of 0.07 to 0.25 MHz.

Figure 38 DBOP data rate

clk_dbop

Clock

prescaler

(inside

CGU)

Control

signal

generator

PCLK

(APB clock)

65 MHz

...

20 MHz

65 MHz

8.125 MHz

20 MHz

2.5 MHz

predivider 1 to 8

Divider /16 or /32

4.06 MHz

0.25 MHz

1.25 MHz

0.07 MHz

Output data rate

Time constraining for the module should be done with 65 MHz, if there is a demand the time constraints for the output pads can be reduced.

7.3.12.8

Interface with GPIO PINs / additional PINs

For the SW, the usage of either ARM primecell GPIO ports or DBOP port can be configured with the GPIOAFSEL registers.

Following IO ports are used for the basic 8 bit interface

xpc[7:0]

for dout[7:0] and din[7:0]

xpb[3:0]

for {C3, C2, C1, C0}

Following IO ports are used for the optional 16 bit interface

xpb[7:4]

for dout[11:8] and din[11:8]

dbop_d[15:12]

for dout[15:12] and din[15:12]

AS3525 bảng dữ liệu(PDF) 92 Page - ams AG

AS3525 bảng dữ liệu(HTML) 92 Page - ams AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL