SH7021 datasheet(124/509 Pages) RENESAS

124 / 509 page

106 RENESAS

•

Bit 12 (burst operation enable (BE)): BE selects whether or not to perform burst operation, a

high speed page mode. When burst operation is not selected (0), the row address is not

compared but instead is transferred to the DRAM every time and full access is performed.

When burst operation is selected (1), row addresses are compared and burst operation with the

same row address as the previous is performed (in this access, no row address is output and the

column address and

CAS signal alone are output).

Bit 12: BE

Description

Normal mode: full access (initial value)

Burst operation: high-speed page mode

•

Bit 11 (CAS duty (CDTY)): CDTY selects 35% or 50% of the TC state as the high-level duty

ratio of the signal

CAS in the short-pitch access. When cleared to 0, the CAS signal high level

duty is 50%; when set to 1, it is 35%. Only set to 1 when the operating frequency is a

minimum of 10 MHz.

Bit 11: CDTY

Description

CAS signal high level duty cycle is 50% of the TC state (initial value)

CAS signal high level duty cycle is 35% of the TC state

•

Bit 10 (multiplex enable bit (MXE)): MXE determines whether or not DRAM row and column

addresses are multiplexed. When cleared to 0, addresses are not multiplexed; when set to 1,

they are multiplexed.

Bit 10: MXE

Description

Multiplex of row and column addresses disabled (initial value)

Multiplex of row and column addresses enabled

•

Bits 9 and 8 (multiplex shift count 1 and 0 (MXC1 and MXC0)): Shift row addresses

downward by a certain number of bits (8–10) when row and column addresses are multiplexed

(MXE = 1). Regardless of the MXE bit setting, these bits also select the range of row addresses

compared in burst operation.

SH7021 bảng dữ liệu(PDF) 124 Page - Renesas Technology Corp