| công cụ tìm kiếm bảng dữ liệu linh kiện điện tử |
|
H8S/2456 bảng dữ liệu(PDF) 441 Page - Renesas Technology Corp |
|
|
|||||||||||||||||||||||||||||
H8S/2456 bảng dữ liệu(HTML) 441 Page - Renesas Technology Corp |
|
441 / 1376 page ![]() Section 8 EXDMA Controller (EXDMAC) Rev. 1.00 Sep. 19, 2008 Page 411 of 1342 REJ09B0467-0100 8.4.3 DMA Transfer Requests (1) Auto Request Mode In auto request mode, transfer request signals are automatically generated within the EXDMAC in cases where a transfer request signal is not issued from outside, such as in transfer between two memories, or between a peripheral module that is not capable of generating transfer requests and memory. In auto request mode, transfer is started when the EDA bit is set to 1 in EDMDR. In auto request mode, either cycle steal mode or burst mode can be selected as the bus mode. Block transfer mode cannot be used. (2) External Request Mode In external request mode, transfer is started by a transfer request signal ( EDREQ) from a device external to this LSI. DMA transfer is started when EDREQ is input while DMA transfer is enabled (EDA = 1). The transfer request source need not be the data transfer source or data transfer destination. The transfer request signal is accepted via the EDREQ pin. Either falling edge sensing or low level sensing can be selected for the EDREQ pin by means of the EDREQS bit in EDMDR (low level sensing when EDREQS = 0, falling edge sensing when EDREQS = 1). Setting the EDRAKE bit to 1 in EDMDR enables a signal confirming transfer request acceptance to be output from the EDRAK pin. The EDRAK signal is output when acceptance and transfer processing has been started in response to a single external request. The EDRAK signal enables the external device to determine the timing of EDREQ signal negation, and makes it possible to provide handshaking between the transfer request source and the EXDMAC. In external request mode, block transfer mode can be used instead of burst mode. Block transfer mode allows continuous execution (burst operation) of the specified number of transfers (the block size) in response to a single transfer request. In block transfer mode, the EDRAK signal is output only once for a one-block transfer, since the transfer request via the EDREQ pin is for a block unit. |
|
Link URL |
| Cho đến nay ALLDATASHEET có giúp ích cho doanh nghiệp của bạn hay không? [ DONATE ] |
Alldatasheet là | Quảng cáo | Liên lạc với chúng tôi | Chính sách bảo mật | Liên kết đến bảng dữ liệu | Trao đổi link | Tìm kiếm theo nhà sản xuất All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |