M32CSLASH8B datasheet(383/406 Pages) RENESAS

383 / 406 page

Under development

M32C/8B Group

25. Usage Notes

Preliminary specification

Specifications in this manual are tentative and subject to change.

REJ09B0450-0050 Rev.0.50 Oct 31, 2008

Page 366 of 385

25.5.4.2

Stop Mode

• The MCU cannot enter stop mode if a low-level (“L”) signal is applied to the NMI pin. Apply an “H” signal

to enter stop mode.

• To exit stop mode by reset, apply an “L” signal to RESET pin until a main clock oscillation stabilizes.

• If using the NMI interrupt to exit stop mode, use the following procedure to set the CM10 bit in the CM1

(Technical update: TN-16C-127A/EA)

(1) Exit stop mode using the NMI interrupt.

(2) Generate a dummy interrupt.

(3) Set the CM10 bit to 1 (all clocks stopped).

e.g.,

int

#63

; dummy interrupt

bset

CM1

; all clocks stopped

/*dummy interrupt routine*/

dummy

reit

• When entering stop mode, the instructions following CM10 = 1 instruction are stored into the instruction

queue, and the program stops. When stop mode is exited, the instruction lined in the queue is executed

before the exit interrupt routine is handled. Insert a jmp.b instruction as follows after the instruction to set

the CM10 bit to 1.

(Technical update: TN-16C-124A/EA)

fset I

; I flag is set to 1

bset 0, cm1

; all clocks stopped (stop mode)

jmp.b LABEL_001

; jmp.b instruction executed (no instruction between jmp.b and LABEL.)

LABEL_001:

nop

; nop(1)

nop

; nop(2)

nop

; nop(3)

nop

; nop(4)

mov.b #0, prcr

; protection set

M32C/8B bảng dữ liệu(PDF) 383 Page - Renesas Technology Corp

M32C/8B bảng dữ liệu(HTML) 383 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

bảng dữ liệu tải về

Link URL