M16CSLASH29 datasheet(79/499 Pages) RENESAS

79 / 499 page

7. Clock Generation Circuit

page 55

Figure 7.9 Examples of Sub Clock Connection Circuit

7.2 Sub Clock

The sub clock is generated by the sub clock oscillation circuit. This clock is used as the clock source for the

CPU clock, as well as the timer A and timer B count sources.

The sub clock oscillator circuit is configured by connecting a crystal resonator between the XCIN and XCOUT

pins. The sub clock oscillator circuit contains a feedback resistor, which is disconnected from the oscillator

circuit during stop mode in order to reduce the amount of power consumed in the chip. The sub clock

oscillator circuit may also be configured by feeding an externally generated clock to the XCIN pin. Figure

7.9

shows the examples of sub clock connection circuit.

After reset, the sub clock is turned off. At this time, the feedback resistor is disconnected from the oscillator

circuit.

To use the sub clock for the CPU clock, set the CM07 bit in the CM0 register to 1 (sub clock) after the sub

clock becomes oscillating stably.

During stop mode, all clocks including the sub clock are turned off. Refer to “power control”.

External Clock

XCIN

XCOUT

Open

VCC

VSS

NOTE:

1. Place a damping resistor if required. Resistance values vary depending on the oscillator setting.

Use values recommended by each oscillator manufacturer.

Place a feedback resistor between XCIN and XCOUT if the oscillator manufacturer recommends

placing the resistor externally.

Oscillator

RCd(1)

CCIN

CCOUT

XCIN

XCOUT

MCU

(Built-in Feedback Resistor)

MCU

(Built-in Feedback Resistor)

VSS

M16C/29 bảng dữ liệu(PDF) 79 Page - Renesas Technology Corp